Multicast Rigid - Thermoplastic

Multicast Rigid Thermoplastic

Back to: Website Index >> Multicast Thermoplastic Splinting

Multicast Rigid is a strong low-temperature thermoplastic material that follows the exact contours of the treated surface. After processing it transforms into a hard splint. It does not need reinforcing, is rigid, light-weight and does not shrink.

Characteristics of Multicast Rigid:

Extra rigidity
Extra strength
Possibility of vertical (anti-gravity) positioning
Recommended for orthosis with large surface

Application of Multicast Rigid:

To soften material, place it into a water bath at 60°C-65°C (140 - 149°F) for 2 minutes or until sufficiently soft.
When ready, remove from the water and lay on a flat, preferably wooden surface.
Wait a few seconds (until bearably warm) and apply onto the patient.

Typical Applications:

VERY GOOD for finger, wrist, metacarpus splint

IDEAL for nose and low back brace

RECCOMENDED for tibia, knee, ankle brace and body splints

Moulding Characteristics:

Transparency	Memory	Drape	Stretch	Bonding	Processing Temperature
Minimum	100%	Maximum	Maximum	Maximum	60 - 65° C